Old Drawers as Planter Boxes: A DIY Guide

Turning old drawers into planter boxes is a satisfying way to repurpose furniture that might otherwise end up in a landfill. With a bit of drilling, lining, and soil, you can create charming, rustic planters for herbs, flowers, or small vegetables. This project is beginner-friendly, requires minimal tools, and can be completed in an afternoon. Before you start, consider where the planters will live—inside on a sunny windowsill or outside on a patio—since that affects the type of wood treatment and drainage you’ll need.

What You’ll Need

  • One or more old wooden drawers (solid wood or plywood; avoid particleboard, which falls apart when wet)
  • Drill with a drill bit (about 1/4 inch or slightly larger)
  • Sandpaper (medium and fine grit)
  • Outdoor wood sealant or paint (if placing outside)
  • Landscape fabric or a plastic liner with drainage holes (like a pond liner or thick trash bag)
  • Staple gun and staples (or heavy-duty tape) to secure the liner
  • Potting soil (not garden soil, which compacts and may contain pests)
  • Plants or seeds of your choice
  • Small stones or gravel for drainage (optional but helpful)
  • Saw or chisel (only if you need to remove the drawer bottom for better drainage)

Step-by-Step

  1. Choose the right drawer. Pick a drawer that is at least 6 inches deep for most plants. Check that the bottom is intact and not rotten. If the drawer has a metal or plastic handle, you can remove it or leave it for a decorative touch.
  2. Clean and sand the drawer. Wipe off dust and debris. Sand all surfaces, especially the inside and edges, to remove splinters and old finish. This also helps the sealant adhere better.
  3. Drill drainage holes. Turn the drawer upside down. Drill several holes evenly spaced across the bottom—about one hole every 4 to 6 inches. If the bottom is thin, use a scrap piece of wood underneath to prevent splitting. If you want better drainage, you can also drill a few holes in the lower sides, about 1/2 inch from the bottom, but keep them small so soil doesn’t escape.
  4. Seal the wood (for outdoor use). If the planter will be outside, apply a coat of outdoor wood sealant or paint to the inside and outside of the drawer. Let it dry completely according to the product instructions. This prevents rot and extends the life of your planter. For indoor use, sealing is optional but recommended to protect surfaces from moisture.
  5. Line the drawer. Cut a piece of landscape fabric or plastic liner to fit inside the drawer, allowing some overlap over the edges. If using plastic, poke small holes in the bottom that align with your drainage holes. Lay the liner inside, then staple it to the inside walls of the drawer, just below the rim. This keeps soil from washing out while still allowing water to escape.
  6. Add a drainage layer (optional). Spread a thin layer of small stones or gravel across the bottom, about 1/2 inch deep. This helps prevent the drainage holes from clogging and keeps soil from staying waterlogged.
  7. Fill with potting soil. Add potting soil until the drawer is about 3/4 full. Gently pat it down, but don’t pack it tightly. If you’re planting seeds, follow the seed packet for depth. For seedlings, dig a hole slightly larger than the root ball.
  8. Plant your greenery. Place your plants, spacing them according to their mature size. Fill in around the roots with more soil, leaving about 1/2 inch of space below the rim to allow for watering. Water thoroughly after planting.
  9. Place and maintain. Set your planter in a spot that matches the light needs of your plants. Water when the top inch of soil feels dry. Fertilize with a balanced liquid fertilizer every few weeks during the growing season, if desired.

Common Mistakes

  • Skipping drainage holes. Without them, water pools at the bottom and rots the roots. Always drill holes, even if you plan to keep the planter indoors.
  • Using untreated particleboard. Particleboard and MDF swell and disintegrate when wet. Stick to solid wood or plywood.
  • Forgetting to seal outdoor planters. Unsealed wood will rot within a season or two. A good sealant makes a huge difference.
  • Overwatering. Drawers are shallower than typical pots, so they dry out faster, but they also hold less water. Check the soil before watering—if it’s still moist, wait.
  • Using garden soil. Garden soil is too dense for containers and can introduce weeds and diseases. Use a quality potting mix.

Tips

  • Add small feet or casters to the bottom of the drawer to improve air circulation and prevent the wood from sitting in water.
  • If the drawer has a front panel that’s taller than the sides, you can leave it as a decorative back—just make sure the plants still get enough light.
  • For a cohesive look, paint all your drawers the same color or use a matching stain.
  • Use a liner that’s slightly larger than the drawer and trim the excess after stapling for a neat finish.
  • Consider attaching a piece of wire mesh or hardware cloth over the drainage holes to keep out pests like slugs.

Troubleshooting

  • Water pools on the surface after watering. This usually means the soil is too compacted or the drainage holes are blocked. Loosen the soil gently with a fork, and check that the holes are clear.
  • Plants are wilting despite regular watering. Overwatering is a common cause. Feel the soil—if it’s soggy, let it dry out before watering again. If the roots are brown and mushy, the plant may have root rot; you may need to repot in fresh soil.
  • The drawer smells musty. This indicates mold or rot from excess moisture. Remove the plant, let the drawer dry out, and improve drainage. If the wood is soft and crumbling, it’s time to replace the drawer.
  • Soil is spilling out of the drainage holes. Your liner might not be covering the holes properly. Add a piece of landscape fabric or a coffee filter over the holes before adding soil.
  • The planter is too heavy to move. Drawers filled with wet soil can be very heavy. Place it in its final spot before filling, or use a plant caddy with wheels.

Frequently Asked Questions

  • Can I use a drawer without drilling holes if I add a layer of gravel? No, gravel alone doesn’t provide adequate drainage—water still sits at the bottom and can cause root rot. Holes are essential.
  • What kind of paint or sealant is safe for vegetables? Look for a sealant labeled as food-safe or non-toxic once cured. Water-based polyurethane or exterior latex paint are good choices. Avoid creosote or oil-based treatments that can leach into the soil.
  • How often should I water a drawer planter? It depends on the plant, weather, and soil. Check the top inch of soil daily—if it’s dry, water until it runs out the bottom. During hot spells, you may need to water daily; in cooler weather, every few days.
  • Can I leave the drawer planter outside in winter? If it’s made of sturdy wood and sealed well, it can stay outside, but the soil may freeze, which can crack the drawer. Move it to a sheltered spot or empty it before hard frosts.
  • What plants grow best in a shallow drawer? Herbs like basil, thyme, and parsley, plus lettuce, radishes, and small flowers like pansies or marigolds. Avoid deep-rooted vegetables like carrots or potatoes.
  • How do I stop the drawer bottom from falling out? If the bottom is loose, reinforce it with a few small screws or nails from the outside, or add a piece of plywood cut to fit inside. You can also use a bead of waterproof wood glue along the joints.
Old Drawers as Planter Boxes: A DIY Guide

Leave a Reply

Your email address will not be published. Required fields are marked *

Scroll to top