Once your lilies finish flowering, the show isn’t over—the plant is busy storing energy for next year’s blooms. Proper post-bloom care keeps the bulbs healthy, encourages more flowers, and prevents common problems like rot and overcrowding. This guide walks you through exactly what to do, from deadheading to dividing, so your lilies come back stronger each season.
What You’ll Need
- Clean, sharp pruning shears or scissors
- Gardening gloves (optional, but helpful)
- Balanced fertilizer (low nitrogen, like a 5-10-10 or similar)
- Mulch (straw, bark, or compost)
- Spade or garden fork (for dividing)
- Watering can or hose
Step-by-Step
- Deadhead spent flowers. Once a lily flower fades and the petals drop, snip off the remaining flower head just above the first set of leaves below it. This prevents the plant from putting energy into seed production. Use clean shears to avoid spreading disease.
- Leave the stem and leaves alone. After deadheading, do not cut back the stem or foliage. The leaves continue photosynthesizing, feeding the bulb for next year. Even if the foliage looks a bit tired, keep it intact until it yellows naturally.
- Remove only the flower stalk once it’s fully brown. When the entire stem turns brown and crispy—usually several weeks after blooming—cut it down to the ground. If you cut too early, the bulb may not store enough energy.
- Feed the bulbs. After flowering, apply a low-nitrogen fertilizer (like a 5-10-10) around the base of the plant, following package directions. Water it in well. This helps replenish nutrients used during blooming.
- Water during dry spells. Lilies prefer consistently moist (but not soggy) soil. If rainfall is scarce, water deeply once a week until the foliage dies back. Reduce watering as the leaves yellow.
- Mulch for winter protection. In late fall, after the ground begins to freeze, apply a layer of mulch (about 2-3 inches) over the planting area. This insulates the bulbs from freeze-thaw cycles. Remove the mulch in early spring as new shoots appear.
- Divide overcrowded clumps (every 3-4 years). If your lilies have formed a dense clump and blooms are getting smaller, dig them up in early autumn (or after foliage dies back). Gently separate the bulbs, discarding any that are soft or damaged. Replant immediately at the same depth (about 3 times the bulb’s height) in well-draining soil.
Common Mistakes
- Cutting back foliage too soon. This is the biggest error. Removing green leaves starves the bulb, leading to fewer or no blooms next year.
- Deadheading by removing the whole stem. Only remove the spent flower head, not the entire stalk, until it’s brown.
- Over-fertilizing with high nitrogen. Too much nitrogen encourages leafy growth at the expense of flowers and can make bulbs rot.
- Letting the soil stay soggy. Lilies hate wet feet; overwatering after bloom can cause bulb rot.
- Dividing too often. Lilies don’t need frequent division; doing it every year stresses them and reduces flowering.
Tips
- If you want to use lilies as cut flowers, cut only a third of the stem at most, leaving the rest to feed the bulb.
- Mark the planting spot with a small label so you don’t accidentally dig into the bulbs while they’re dormant.
- For container-grown lilies, move the pot to a cool, dry place after the foliage dies back, and keep the soil barely moist until spring.
- If you live in a very cold climate, consider lifting tender lily bulbs (like some hybrids) and storing them in a cool, dry place over winter, then replant in spring.
- Remove any seed pods that form—they drain energy from the bulb.
Troubleshooting
- Leaves turn yellow early. This could be overwatering or poor drainage. Check the soil—if it’s waterlogged, improve drainage by adding grit or moving the plant. If it’s just natural aging, leave it.
- No blooms next year. Usually caused by cutting foliage too early or insufficient sunlight. Ensure lilies get at least 6 hours of sun and let leaves die back naturally.
- Bulbs rotting. Soft, mushy bulbs indicate fungal rot. Dig up the bulbs, cut away affected parts, dust with fungicide (if available), and replant in well-draining soil. Avoid watering too much.
- Pests like aphids or lily beetles. If you see holes in leaves or insects, hand-pick them off (wear gloves) or spray with a gentle insecticidal soap. Do not use harsh chemicals that harm pollinators.
- Foliage flops over. If stems are weak, they may need staking. Insert a stake early in the season and tie loosely. Also, ensure the plant isn’t overcrowded.
- No flowers at all. This might be due to too much shade, poor soil, or bulbs planted too shallow. Move them to a sunnier spot, enrich soil with compost, and replant at proper depth.
Frequently Asked Questions
Should I cut back lilies after they bloom? Not immediately. Only remove the spent flower heads. Wait until the foliage yellows naturally before cutting the stem to the ground.
Can I leave lily bulbs in the ground over winter? Yes, most hardy lilies (like Asiatic and Oriental types) can stay in the ground if the soil drains well. In very cold areas, add a thick mulch for insulation.
When is the best time to divide lilies? Early autumn, after the foliage has died back, is ideal. This gives the bulbs time to establish before winter.
Why are my lily leaves turning brown? It’s normal for leaves to brown and die back after flowering—this is the plant storing energy. If it happens before bloom, check for pests or disease.
Do lilies need fertilizer after blooming? Yes, a low-nitrogen fertilizer helps the bulb rebuild its energy reserves. Apply it right after flowering and water it in.
Can I grow lilies in pots? Absolutely. Use a deep pot with good drainage, plant bulbs at the proper depth, and after blooming, let the foliage die back before moving the pot to a cool, dry place.