How to Lay Landscape Fabric Around a Pool

Laying landscape fabric around a pool is a smart way to keep weeds from pushing through your gravel, stone, or mulch while still letting water drain down to the soil below. It creates a clean, low-maintenance border that looks tidy for years. Before you start, make sure the ground is level and free of large rocks or old roots. You’ll also want to pick a sunny day—the fabric is easier to handle when it’s dry, and you’ll be able to see exactly where the edges lie.

What You’ll Need

  • Landscape fabric (woven or non-woven, depending on your mulch or stone)
  • Scissors or a utility knife
  • Landscape fabric pins (U-shaped staples)
  • Measuring tape
  • Shovel or spade (for edging)
  • Rake (to smooth the soil)
  • Optional: edging material (plastic, metal, or stone) to hold the fabric in place

Step-by-Step

  1. Clear the area. Remove any existing weeds, grass, or debris from the strip around the pool. Use a shovel to cut a clean edge along the pool deck and any lawn or garden border. This gives you a defined area to work in.
  2. Level the soil. Rake the ground so it’s smooth and slightly sloping away from the pool. This helps water run off and prevents puddles. Fill in low spots with extra soil and tamp it down lightly.
  3. Lay the fabric. Unroll the landscape fabric over the prepared soil. Start at one end and let it overlap the pool deck edge by a few inches—you can trim it later. If you need multiple strips, overlap them by at least six inches so weeds can’t sneak through the seams.
  4. Cut to fit. Use scissors or a utility knife to trim the fabric along the pool deck and any curves. Leave a small allowance (about an inch) so you can tuck the edge under the deck or edging material later.
  5. Secure with pins. Push landscape fabric pins through the fabric into the soil every few feet along the edges and at the seams. Space them about one to two feet apart for a snug fit. If the ground is hard, use a hammer to tap the pins in—just be careful not to hit your fingers.
  6. Cut holes for plants (if any). If you’re planting shrubs or flowers near the pool, make an X-shaped cut in the fabric where each plant goes. Fold back the flaps, dig the hole, place the plant, then fold the fabric back around the base. Secure the flaps with pins.
  7. Cover with mulch or stone. Spread your chosen ground cover—gravel, pebbles, or mulch—over the fabric. Aim for a depth of two to three inches. This hides the fabric, holds it down, and gives the area a finished look.
  8. Trim the edges. Once the mulch or stone is in place, use scissors to trim any visible fabric along the pool deck or edging. Tuck the trimmed edges under the edging or deck lip so they’re not exposed.

Common Mistakes

  • Skipping the soil prep. If you don’t remove existing weeds or level the ground, the fabric won’t lie flat and weeds may still push through.
  • Not overlapping seams. Gaps between strips of fabric are an open invitation for weeds. Always overlap by at least six inches.
  • Using too few pins. Wind, foot traffic, and shifting stone can move fabric that isn’t secured. Pin it down generously, especially along edges and seams.
  • Cutting holes too early. If you cut holes for plants before you’ve laid the fabric flat, the holes may end up in the wrong place. Mark plant locations first, then cut.
  • Forgetting drainage. Landscape fabric is meant to let water through, but if you use a non-woven type that’s too dense, water may pool on top. Choose a fabric that’s rated for drainage.

Tips

  • Choose a woven fabric for areas with heavy foot traffic or large stone. Woven fabric is more durable and less likely to tear.
  • If you’re using mulch, pick a fabric with small pores so the mulch doesn’t work its way down into the soil over time.
  • Install edging (like metal or plastic strips) along the outside edge of the fabric to keep mulch or stone from spilling onto your lawn.
  • Work in sections—don’t try to lay a huge roll all at once. It’s easier to manage and you’ll get a smoother result.
  • On a hot day, the fabric can get warm and sticky. Wear gloves and take breaks if needed.

Troubleshooting

  • Fabric wrinkles or bubbles. Smooth it out and re-pin. If the ground is uneven, add or remove soil underneath before re-laying.
  • Weeds still appear. Check for gaps at seams or edges. Add more pins and overlap any exposed areas with a patch piece of fabric.
  • Water pools on top of the fabric. This usually means the fabric is too dense or the soil underneath is compacted. Loosen the soil before laying, or switch to a more permeable fabric.
  • Mulch or stone slides off the fabric. Install edging to create a physical barrier, or use larger, heavier stone that stays put.
  • Fabric tears during installation. Patch it with a scrap piece and secure with pins. For future projects, use a thicker woven fabric.

Frequently Asked Questions

How long does landscape fabric last? Quality fabric can last for years, but UV exposure and foot traffic can degrade it. Replace it when you notice tears or weeds breaking through.

Do I need to remove the grass before laying fabric? Yes, it’s best to remove grass and weeds first. If you leave them, they may decompose and create uneven spots, and some aggressive weeds can push through.

Can I lay fabric directly on sand? Yes, but sand shifts easily, so you’ll need extra pins and a heavier fabric. Consider adding a layer of crushed stone on top to stabilize it.

Should I use fabric under gravel or mulch? Both work, but gravel is heavier and can puncture thin fabric, so use a woven type. Mulch is lighter and works with most fabrics.

How do I cut fabric around pool pipes or fixtures? Make small cuts and fold the fabric around the obstacle, then secure with pins. Avoid cutting large holes that leave gaps.

Can I lay fabric over tree roots? It’s possible, but roots may push up and tear the fabric over time. Consider using a flexible edging to accommodate movement.

How to Lay Landscape Fabric Around a Pool

Leave a Reply

Your email address will not be published. Required fields are marked *

Scroll to top