Removing a laurel shrub is a physical job, but a straightforward one. This guide covers the most reliable methods for killing a laurel and keeping it from coming back, whether you are dealing with a small hedge or a large, established bush. The key is to remove the root system or exhaust it completely; laurel is vigorous and will regrow from any significant root left in the ground. You will need to decide between digging it out entirely or using a cut-and-treat method with a herbicide. Both are covered below.
What You’ll Need
- Work gloves (thick, preferably leather)
- Safety glasses or goggles
- Long-sleeved shirt and pants
- Pruning saw or reciprocating saw (for thick stems)
- Loppers (for smaller branches)
- Spade or digging shovel
- Pickaxe or mattock (for stubborn roots, especially on larger shrubs)
- A sturdy pry bar or digging bar (to lever out root balls)
- Stump grinder (optional, for large stumps)
- Concentrated glyphosate herbicide (for the cut-stump method)
- A small paintbrush or spray bottle for the herbicide
- Heavy-duty trash bags or a tarp for disposal
- Wood chipper or access to a green waste facility (for disposal)
Step-by-Step
Method A: Digging Out the Shrub (Best for Small to Medium Shrubs)
- Cut back the top growth. Use loppers or a pruning saw to cut the laurel down to a stump about a foot tall. This makes the root ball easier to access and gives you something to grip or lever against.
- Dig a trench around the base. Start about a foot away from the main trunk. Dig down, angling the spade inward toward the center of the root ball. The goal is to sever the lateral roots that spread outward.
- Work your way around the shrub. Continue digging and cutting roots all the way around. Use the pickaxe to break up dense soil and cut through thicker roots.
- Lever out the root ball. Once you have cut the major lateral roots, insert the pry bar or the spade under the main root ball and push down to lever it upward. Rock it back and forth to loosen it. For a large shrub, you may need to cut the central taproot with the saw or axe.
- Remove the root ball. Pull the entire root ball out of the hole. Shake off loose soil.
- Rake and pick out remaining roots. Go through the soil in the hole and the surrounding area, removing any roots thicker than your finger. Laurel can resprout from these fragments.
- Backfill the hole. Fill the hole with the excavated soil, or fresh topsoil if you prefer, and tamp it down.
Method B: Cut-Stump Herbicide Treatment (Best for Large Shrubs or Tough Stumps)
- Cut the shrub down. Use a pruning saw or reciprocating saw to cut the main trunk as close to the ground as possible. A flat, horizontal cut is essential.
- Immediately apply herbicide. Within a few minutes of cutting, brush a concentrated glyphosate herbicide onto the freshly cut surface of the stump. Cover the entire outer ring of the cut, which is the living cambium layer. Do not drench the center of the stump.
- Wait for the herbicide to work. The herbicide will be transported down into the root system. This takes a few weeks. You may see the stump try to sprout; this is normal.
- Monitor and re-treat if needed. If you see new green shoots emerging from the stump after a few weeks, cut them off and apply a small amount of herbicide to the fresh cut.
- Remove the dead stump. Once the stump is clearly dead (no green growth, wood is dry and brittle), you can dig it out, or leave it to rot naturally. Digging is easier now because the roots are dead.
Common Mistakes
- Leaving root fragments. The single biggest mistake is leaving a piece of root in the ground. Laurel will reliably resprout from even a small section.
- Applying herbicide on a rainy day. Rain will wash the herbicide off the stump before it can be absorbed. Check the forecast and pick a dry day.
- Using a weak herbicide solution. For the cut-stump method, you need a concentrated product, not a ready-to-use spray. Diluted solutions are not effective on a woody stump.
- Cutting the stump flush with the ground. If you cut below soil level, you cannot easily see or treat the stump. Leave it slightly above ground.
- Skipping the lateral roots. When digging, it is tempting to just pull on the trunk. You must cut the lateral roots first, or you will just snap the top off the root ball, leaving the rest in the soil.
Tips
- Water the soil a day before digging. Moist soil is much easier to dig than dry, hard-packed soil. Water deeply the day before you plan to dig.
- Use a sharp blade. A sharp pruning saw or loppers makes clean cuts, which are easier to treat with herbicide and require less effort.
- Treat the stump immediately. The fresher the cut, the more effectively the herbicide is absorbed. Do not let the cut surface dry out.
- Consider the time of year. Late summer to early fall is often the best time for herbicide application, as the plant is moving energy down to its roots. Spring is fine for digging.
- For a large hedge, work in sections. Do not try to dig out an entire hedge in one day. Remove one or two shrubs at a time.
- Rent a stump grinder for massive stumps. If you have a very large, old laurel stump, a stump grinder is far more efficient than digging by hand.
Troubleshooting
- New shoots appearing after digging. This means you missed a root fragment. Dig down around the shoot and trace it back to the root, then remove the entire root piece.
- Stump is resprouting vigorously after herbicide. The herbicide may not have been strong enough, or it was washed off. Cut the new growth off flush with the stump and apply a fresh, concentrated dose of herbicide immediately.
- The root ball is too heavy to lift. Do not try to lift it whole. Use the pry bar to break it into smaller pieces, or cut through the root ball with the saw to split it into manageable sections.
- Soil is full of rocks and impossible to dig. Stop digging and switch to the cut-stump herbicide method. It avoids the need to dig entirely.
- You are not sure if the shrub is dead. Scratch the bark with a fingernail. If the layer underneath is green, it is still alive. If it is brown and dry, it is dead.
Frequently Asked Questions
Q: Will bleach kill a laurel stump?
A: No. Bleach is not an effective herbicide. It will damage the outer tissue but will not travel down to the roots, so the stump will likely resprout.
Q: Can I just cut the laurel down to the ground and leave it?
A: You can, but it will almost certainly regrow from the stump and roots. Cutting alone does not kill the plant.
Q: How long does it take for a cut stump to die?
A: With a proper herbicide treatment, it can take several weeks to a few months for the roots to die completely. Without herbicide, it may never die.
Q: Is it safe to compost the roots and branches?
A: Only if you are certain the plant is dead. Laurel roots and stems can resprout in a compost pile. It is safer to dispose of them at a green waste facility or let them dry out completely on a tarp for a few months before composting.
Q: Can I burn the removed laurel?
A: Check your local regulations first. Many areas restrict burning. If allowed, ensure the wood is dry and follow all local fire safety rules.
Q: What is the best time of year to kill a laurel?
A: For digging, any time the ground is not frozen. For herbicide treatment, late summer to early fall is often most effective because the plant is storing energy in its roots for winter.