Khadi cotton is a hand-spun, hand-woven fabric from India. Its slightly irregular texture and breathable feel come from the handmade process, which also makes every piece unique. This guide explains how khadi is made and how to care for it so it lasts.
What You’ll Need
- Raw cotton fiber (or recycled cotton scraps)
- A spinning wheel (charkha) or a hand spindle
- A handloom (frame loom or table loom)
- Scissors
- Mild detergent (for washing)
- Clean towels
Step-by-Step
- Prepare the fiber. Start with clean, dry cotton fiber. Remove seeds, leaves, and any debris. If the fiber is compacted, gently fluff it with your fingers or a hand carder to align the fibers in one direction.
- Spin the yarn. Attach a small tuft of fiber to the spindle or the charkha’s hook. With one hand, draw the fiber back while the other turns the wheel or spindle. The twist will form a continuous yarn. Keep the yarn thickness even by feeding fiber steadily. Continue until you have enough yarn for your project.
- Set the twist. Once spun, the yarn is twisted and lively. Soak the skeins in lukewarm water for a few minutes, then hang them to dry with a small weight (like a clean stone) to straighten them. This sets the twist and makes the yarn easier to weave.
- Warp the loom. Measure the length of fabric you want and cut the warp yarns accordingly. Thread each warp yarn through the heddles and reed of your loom, following your loom’s instructions. Tie the warp ends to the front and back beams. This is the most time-consuming step; take it slowly.
- Weave the weft. Wind the weft yarn onto a shuttle. Pass the shuttle through the shed (the opening between warp threads) from one side to the other. Beat the weft with the reed to pack the threads closely. Alternate the shed by changing the treadle or lever, and pass the shuttle back. Repeat until the fabric reaches your desired length.
- Remove and finish. Cut the fabric off the loom, leaving extra yarn at the ends. Tie loose warp threads in small knots to prevent unraveling. Hand-wash the fabric in cold water with a mild detergent to remove any spinning or weaving oils. Rinse well, then gently squeeze out excess water (do not wring).
- Dry and press. Lay the fabric flat on a clean towel, roll it up to absorb moisture, then hang to dry out of direct sunlight. When almost dry, press with a warm iron on the cotton setting. This smooths the weave and gives it a crisp finish.
Common Mistakes
- Spinning too tightly, which makes the yarn kink and hard to weave.
- Pulling the warp too tight, causing the fabric to have uneven edges or a distorted shape.
- Skipping the twist-setting step, leading to a yarn that tangles and breaks during weaving.
- Washing in hot water or using bleach, which shrinks and damages the fibers.
- Wringing the wet fabric, which creases it permanently and weakens the threads.
Tips
- Start with a small project like a scarf or a hand towel to practice before making a full garment.
- Use a finer yarn for clothing and a thicker yarn for home textiles like table runners.
- If you don’t have a spinning wheel, a hand spindle works just as well; it just takes longer.
- Keep your hands clean and dry while spinning to avoid staining the fiber.
- For a softer fabric, wash and dry the finished khadi a few times; it becomes more supple with each wash.
Troubleshooting
- Yarn keeps breaking during spinning: Your twist is too high or the fiber is too thin. Reduce the twist by spinning slower, and add more fiber to the drafting zone.
- Fabric edges are wavy: The warp tension is uneven. Check that all warp threads are equally tight; adjust the tension on the beam.
- Weave is too loose: Beat the weft more firmly with each pass, or use a reed with more dents per inch.
- Fabric feels stiff after washing: You may have used too much detergent or not rinsed enough. Rewash with a small amount of mild soap and rinse thoroughly. A fabric softener (vinegar in the rinse water) can help.
- Color bleeding: If you dyed the yarn, the first few washes may release excess dye. Wash separately in cold water until the water runs clear.
Frequently Asked Questions
Is khadi the same as handloom? No. Khadi specifically means hand-spun and hand-woven. Handloom fabric can be woven by hand but the yarn may be mill-spun.
Why is khadi more expensive than regular cotton? Because it is labor-intensive. Each step, from spinning to weaving, is done by hand, which takes many hours and requires skilled artisans.
Can I machine-wash khadi? Yes, but use a gentle cycle with cold water and mild detergent. Hand-washing is gentler and extends the fabric’s life.
Does khadi shrink? It can shrink a little on the first wash. Pre-wash the fabric before sewing to avoid surprises.
Is khadi only made from cotton? No. Khadi can also be made from silk or wool, though cotton is the most common. The process is the same: hand-spun and hand-woven.
How do I remove wrinkles from khadi? Iron while the fabric is slightly damp on a medium-hot setting. Khadi wrinkles easily, but that is part of its natural charm.