Fertilizing through landscape fabric lets you feed established beds without pulling back the fabric or cutting it open. The fabric blocks weeds but still lets water and liquid nutrients pass through to the soil below. This guide covers the best way to do it, what to use, and how to avoid common problems.
What You’ll Need
- Liquid fertilizer (water-soluble type, either concentrate or ready-to-use)
- A watering can with a narrow spout, or a hose-end sprayer
- A bucket or large container for mixing (if using concentrate)
- A stir stick or old spoon
- Measuring cup or cap from the fertilizer bottle
- Water source (hose or faucet)
- Optional: a garden trowel to check soil moisture
- Optional: a spray bottle for small pots or containers
Step-by-Step
- Check the fertilizer label. Read the mixing instructions on your liquid fertilizer. Some are concentrated and need dilution; others are ready to use. Follow the label’s ratio for the size of your bed. If the label gives a range, start with the lower end to avoid burning plants.
- Water the bed first (if soil is dry). If the soil under the fabric is very dry, give the area a light watering with plain water. This helps the fertilizer spread evenly and prevents a concentrated dose from hitting dry roots. Wait a few minutes for the water to soak in.
- Mix the fertilizer solution. In your bucket or watering can, combine the liquid fertilizer with water according to the label. Stir well with your stick or spoon until fully dissolved. If using a hose-end sprayer, attach the fertilizer bottle per its instructions and set the dial to the correct dilution.
- Apply directly over the fabric. Slowly pour or spray the fertilizer solution over the landscape fabric, aiming at the root zone of each plant. You don’t need to cover the entire fabric—focus on where the roots are. For rows of plants, pour a steady line along the base of each plant. For individual shrubs or perennials, pour a circle around each stem, staying a few inches away from the trunk or crown.
- Let it soak in. The solution will pass through the fabric and into the soil. If you see puddles on top of the fabric, pause and let them absorb before adding more. The fabric is porous, so it should drain quickly.
- Follow with plain water (optional but helpful). After applying the fertilizer, give the same area a light rinse with plain water. This washes any fertilizer residue off the fabric surface and pushes the nutrients deeper into the soil. It also prevents the fertilizer from drying and leaving a crust on the fabric.
- Clean your equipment. Rinse the watering can, bucket, and any sprayer parts with plain water after use. Fertilizer left in equipment can corrode metal or clog sprayer nozzles.
Common Mistakes
- Using dry granular fertilizer on top of fabric. Granules sit on the fabric and don’t break down properly. They may wash away or burn plants when they finally dissolve. Always use liquid fertilizer for fabric-covered beds.
- Pouring too fast. A quick dump of fertilizer solution runs off the fabric instead of soaking through. Pour slowly and steadily.
- Fertilizing when soil is bone dry. Dry soil repels water, and the solution may run off or pool. Water first, then fertilize.
- Over-fertilizing. Because the fabric traps some moisture, plants in fabric beds can be more sensitive to salt buildup from too much fertilizer. Stick to the label’s recommended frequency, usually every few weeks during the growing season.
- Forgetting to check the fabric’s age. Old fabric can become clogged with soil and organic matter, making it less permeable. If water pools on top, the fabric may need replacement or at least aeration.
Tips
- Use a watering can with a rose (sprinkler head) for even distribution. A narrow spout concentrates the liquid, which is fine for individual plants but less even for beds.
- Fertilize in the morning. This gives plants the full day to absorb nutrients and allows any moisture on the fabric to evaporate, reducing the risk of fungal issues.
- Consider a slow-release liquid feed. Some liquid fertilizers are formulated to release nutrients gradually. These are easier on fabric beds because they require less frequent application.
- Keep a log of when you fertilize. Note the date and what you used. This helps you avoid over-feeding and track what works for your plants.
- For large beds, use a hose-end sprayer. It saves time and gives more even coverage than a watering can.
- Test the soil every couple of years. Fabric doesn’t change soil chemistry, but your plants do. A simple soil test tells you if you’re missing nutrients.
Troubleshooting
- Water pools on top of the fabric. This means the fabric is clogged or the soil below is compacted. Try poking small holes in the fabric with a screwdriver or trowel to improve drainage. If that doesn’t help, the fabric may be too old and need replacing.
- Fertilizer runs off the fabric and onto paths. Slow down your pour and use a lower spray setting. You can also create a small berm or edge of soil around the bed to catch runoff.
- Plants look yellow despite fertilizing. The fertilizer may not be reaching the roots, or the soil pH may be off. Check that the fabric is actually wet after watering. If it is, test your soil pH—some nutrients are unavailable at certain pH levels. Also, check that you’re using the right fertilizer type for your plants (e.g., acidic for blueberries).
- White crust forms on the fabric. This is salt residue from fertilizer. Rinse the fabric thoroughly with plain water to wash it away. In the future, water more deeply after fertilizing.
- Weeds are growing through the fabric. This usually means the fabric has torn or has gaps at the edges. Patch small holes with a piece of new fabric, and tuck fabric edges under mulch or soil.
- Plants are wilting after fertilizing. This could be fertilizer burn from too strong a solution. Flush the area with plenty of plain water to dilute the concentration in the soil. Wait a week before fertilizing again, and use a weaker mix next time.
Frequently Asked Questions
Can I use granular fertilizer under landscape fabric?
Yes, but it must be placed in the soil before the fabric is laid, not on top afterward. Once fabric is down, use only liquid fertilizer.
How often should I fertilize through landscape fabric?
It depends on the plants and the fertilizer. Most liquid fertilizers are applied every few weeks during the growing season. Check the label and adjust based on plant response.
Will landscape fabric block the fertilizer?
No. Quality landscape fabric is porous and allows water and dissolved nutrients to pass through. If it blocks water, it’s clogged or the wrong type.
Can I use a drip irrigation system with fertilizer through fabric?
Yes. You can inject liquid fertilizer into a drip line placed under or on top of the fabric. This is an efficient way to feed fabric-covered beds.
Do I need to remove mulch before fertilizing?
No. If you have mulch on top of the fabric, just pour or spray the fertilizer over the mulch. It will soak through both layers.
Is it better to fertilize before or after rain?
Before rain can wash the fertilizer away, especially if it’s heavy. After rain, the soil is moist and ready to absorb nutrients. Aim for after a light rain or after watering.