If your Chinese evergreen (Aglaonema) is looking sad, with yellowing leaves, drooping stems, or brown tips, it’s usually a sign that something in its care routine is off. This guide walks you through the most common causes and gives you clear, step-by-step fixes to help your plant bounce back. Before you start, check the soil moisture, the light levels, and the temperature of the room—these are the usual culprits.
What You’ll Need
- Clean, sharp scissors or pruning shears
- A pot with drainage holes (if repotting)
- Fresh, well-draining potting mix (a houseplant or aroid mix works well)
- Room-temperature water
- A moisture meter (optional, but helpful)
- Insecticidal soap or neem oil (if pests are present)
Step-by-Step
- Assess the watering situation. Stick your finger about an inch into the soil. If it feels bone dry, the plant is likely underwatered. If it feels soggy or wet, you’re probably overwatering. Chinese evergreens like to dry out a bit between waterings, but not completely.
- Check the roots. Gently slide the plant out of its pot. Healthy roots are firm and white or light tan. If they’re brown, mushy, or smell bad, root rot has set in. If the roots are circling the pot tightly, the plant is root-bound.
- Adjust your watering routine. For underwatering: water thoroughly until water runs out of the drainage holes, then let it drain completely. For overwatering: let the soil dry out more between waterings. In most homes, that means watering every one to two weeks, but always check the soil first.
- Move it to a better light spot. Chinese evergreens prefer bright, indirect light. Too much direct sun can scorch the leaves, causing brown patches. Too little light can lead to slow growth and loss of leaf color. A spot near a north or east window is usually ideal.
- Check the temperature and humidity. These tropical plants like warmth and humidity. Keep them away from drafts, air conditioners, and heating vents. If your air is very dry, especially in winter, increase humidity by placing a pebble tray with water under the pot or using a small humidifier nearby.
- Trim away dead or dying foliage. Using clean scissors, cut off any yellow, brown, or mushy leaves at the base. This helps the plant focus its energy on healthy growth. Also remove any soft, rotting stems.
- Repot if needed. If the roots are rotten or the plant is root-bound, repot into a pot that is one size larger, with fresh potting mix. Make sure the new pot has drainage holes. Gently loosen the roots, place the plant at the same depth it was before, and water lightly.
- Treat for pests. Look under the leaves and along the stems for small insects like spider mites, mealybugs, or scale. If you see any, wipe the leaves with a damp cloth, then apply an insecticidal soap or neem oil according to the product’s instructions. Repeat as needed.
- Be patient. After you’ve made these adjustments, give your plant a few weeks to recover. It may drop a few more leaves, but that’s normal. New growth is a positive sign.
Common Mistakes
- Watering on a strict schedule. Instead of watering every Monday, check the soil each time. The plant’s needs change with the seasons and light levels.
- Using cold water. Cold water can shock the roots. Always use room-temperature water.
- Leaving it in a dark corner. While they tolerate low light, they won’t thrive in it. If the plant is in a dim room, it may slowly decline.
- Ignoring the humidity. In dry indoor air, the leaf tips often turn brown. This is a sign to add humidity, not to water more.
- Fertilizing a sick plant. Don’t fertilize a stressed or dying plant. It can burn the roots. Wait until the plant shows signs of recovery.
Tips
- Use a pot with drainage holes. Never let the plant sit in standing water.
- Dust the leaves occasionally with a damp cloth. This helps the plant photosynthesize better.
- Group your plants together. They create a microclimate with higher humidity.
- If you’re repotting, choose a pot that is only slightly larger than the current one. A pot that’s too big can hold excess water and cause root rot.
- Consider using filtered or distilled water if your tap water is very hard, as mineral buildup can cause leaf tip burn.
Troubleshooting
If the plant still looks worse after a week:
- Yellow leaves that are mushy: This usually means overwatering. Unpot the plant, cut away any rotten roots, and repot in fresh, dry mix. Water sparingly for a few weeks.
- Brown, crispy leaf edges: This is often low humidity or too much fertilizer. Increase humidity and flush the soil with water to remove excess salts.
- Leaves curling or drooping: Could be underwatering or a sudden temperature change. Check the soil and move the plant to a more stable environment.
- Pale, washed-out leaves: This indicates too much direct light. Move the plant to a shadier spot.
- No new growth for months: The plant may be root-bound or in a spot that’s too dark. Check the roots and move it to brighter, indirect light.
- If you see tiny webs or sticky residue: Spider mites or other pests are present. Treat with insecticidal soap and increase humidity, as mites thrive in dry conditions.
Frequently Asked Questions
Q: How often should I water my Chinese evergreen?
A: It depends on your home’s conditions. Generally, water when the top inch of soil feels dry. This might be every week or so, but always check the soil first.
Q: Why are the leaves turning yellow?
A: The most common cause is overwatering. Check the soil moisture and the roots. If the roots are rotting, you’ll need to repot. Yellowing can also be a sign of too much direct sun or a nutrient deficiency.
Q: Can I save a Chinese evergreen with root rot?
A: Yes, if caught early. Remove the plant from the pot, cut away all mushy, dark roots, and repot in fresh, well-draining soil. Water very sparingly until you see new growth.
Q: Is my Chinese evergreen toxic to pets?
A: Yes, Chinese evergreens are toxic to cats and dogs if ingested. They contain calcium oxalate crystals, which can cause mouth irritation, drooling, and vomiting. Keep them out of reach of pets.
Q: Why does my plant have brown tips on the leaves?
A: Brown tips are usually caused by low humidity, mineral buildup from tap water, or over-fertilizing. Increase humidity, use filtered water, and flush the soil occasionally.
Q: Can I propagate a dying Chinese evergreen?
A: Yes, if the stem is still healthy. Cut a stem with a few leaves, place it in water, and wait for roots to develop. Then pot it in soil. This is a good way to save a plant that’s failing at the base.